====== Sensor RTCGQ11LM ======

Sensor de presencia y luminosidad

{{ https://m.media-amazon.com/images/I/41YaCoSEddL.jpg?300 |}}
===== Información técnica =====

  * Indentificador: ''RTCGQ11LM''
  * Dimensiones: 30 x 30 x 33mm
  * Protocolo de comunicación: Zigbee
  * Rango de operación: 
    * Temperatura: -10 ºC ~ 45 ºC (precisión de ±0,3 ºC)
    * Humedad relativa: 0 ~ 95 % (precisión de ±3 %)
  * Marca: Aqara
  * Batería: CR2450

===== Home Assistant =====

Se utiliza a través del add-on **zigbee2mqtt**

==== Emparejamiento ====

Mantener pulsado el botón de reset (en un lateral) durante unos 5 segundos (hasta que comience a parpadear un LED azul). Si esto no funcionase, prueba con una pulsación corta.

<code>
Zigbee2MQTT:info  2024-02-29 23:30:47: Device '0x00158d00033c192a' joined
Zigbee2MQTT:info  2024-02-29 23:30:47: MQTT publish: topic 'zigbee2mqtt/bridge/event', payload '{"data":{"friendly_name":"0x00158d00033c192a","ieee_address":"0x00158d00033c192a"},"type":"device_joined"}'
Zigbee2MQTT:info  2024-02-29 23:30:47: Starting interview of '0x00158d00033c192a'
Zigbee2MQTT:info  2024-02-29 23:30:47: MQTT publish: topic 'zigbee2mqtt/bridge/event', payload '{"data":{"friendly_name":"0x00158d00033c192a","ieee_address":"0x00158d00033c192a","status":"started"},"type":"device_interview"}'
Zigbee2MQTT:info  2024-02-29 23:30:47: MQTT publish: topic 'zigbee2mqtt/bridge/event', payload '{"data":{"friendly_name":"0x00158d00033c192a","ieee_address":"0x00158d00033c192a"},"type":"device_announce"}'
Zigbee2MQTT:info  2024-02-29 23:30:47: MQTT publish: topic 'zigbee2mqtt/bridge/event', payload '{"data":{"friendly_name":"0x00158d00033c192a","ieee_address":"0x00158d00032c192a"},"type":"device_announce"}'
(...)
Zigbee2MQTT:info  2024-02-29 23:32:35: Successfully interviewed '0x00158d00033c192a', device has successfully been paired
</code>

En ''/share/zigbee2mqtt/devices.yaml'' se incluye con el identificador que le da zigbee2mqtt tras emparejarse, pero podemos indicar un nombre más representativo con ''friendly_name'':

<code yaml>
</code>

Para usarlo en Home Assistant, vamos a ''/config/configuration.yaml'':

<code yaml>

</code>